NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual 274, Setting Description

ProSecure Unified Threat Management (UTM) Appliance

Table 64. IPSec VPN Wizard settings for a client-to-gateway tunnel (continued)

Setting	Description
This VPN tunnel will use	Select a WAN interface from the drop-down list to specify which local WAN
following local WAN	interface the VPN tunnel uses as the local endpoint.
Interface (multiple WAN port
	Select the Enable RollOver? check box to enable VPN rollover, and then
models only)
	select a WAN interface from the drop-down list to the right of the check box to
	specify the interface to which the VPN rollover should occur.
	Note: If the multiple WAN port model is configured to function in WAN
	auto-rollover mode, you can use the VPN Wizard to configure VPN rollover
	and do not need to configure this manually.
Connection Name and Remote IP Type
What is the new Connection	Enter a descriptive name for the connection. This name is used to help you to
Name?	manage the VPN settings; the name is not supplied to the remote VPN
	endpoint.
What is the pre-shared key?	Enter a pre-shared key. The key needs to be entered both here and on the
	remote VPN gateway, or the remote VPN client. This key needs to have a
	minimum length of 8 characters and cannot exceed 49 characters.
End Point Informationa
What is the Remote	When you select the Client radio button in the About VPN Wizard section of
Identifier Information?	the screen, the default remote FQDN (utm_remote1.com) is automatically
	entered. Use the default remote FQDN, or enter another FQDN.
What is the Local Identifier	When you select the Client radio button in the About VPN Wizard section of
Information?	the screen, the default local FQDN (utm_local1.com) is automatically
	entered. Use the default local FQDN, or enter another FQDN.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?	These fields are masked out for VPN client connections.
What is the remote LAN
Subnet Mask?

a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and an FQDN is not supported.

3.Click Apply to save your settings. The IPSec VPN policy is now added to the List of VPN Policies table on the VPN Policies screen. By default, the VPN policy is enabled.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

274