NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual DNS server settings, Identifier check box

ProSecure Unified Threat Management (UTM) Appliance

Table 15. Internet IP address settings

Setting	Description
Get Dynamically	If your ISP has not assigned you a static IP address, select the Get Dynamically from
from ISP	ISP radio button. The ISP automatically assigns an IP address to the UTM using DHCP
	network protocol.
	Client Identifier	If your ISP requires the client identifier information to assign an
		IP address using DHCP, select the Client Identifier check box.
	Vendor Class Identifier	If your ISP requires the vendor class identifier information to
		assign an IP address using DHCP, select the Vendor Class
		Identifier check box.
Use Static IP	If your ISP has assigned you a fixed (static or permanent) IP address, select the Use
Address	Static IP Address radio button, and enter the following settings:
	IP Address	Static IP address assigned to you. This address identifies the
		UTM to your ISP.
	Subnet Mask	The subnet mask is usually provided by your ISP.
	Gateway IP Address	The IP address of the ISP’s gateway is usually provided by
		your ISP.

8.In the Domain Name Server (DNS) Servers section of the screen (see the following figure), specify the DNS settings as explained in the following table.

Figure 43.

Table 16. DNS server settings

Setting	Description
Get Automatically	If your ISP has not assigned any Domain Name Server (DNS) addresses, select the
from ISP	Get Automatically from ISP radio button.
Use These DNS	If your ISP has assigned DNS addresses, select the Use These DNS Servers radio
Servers	button. Make sure that you fill in valid DNS server IP addresses in the fields. Incorrect
	DNS entries might cause connectivity issues.
	Primary DNS Server	The IP address of the primary DNS server.
	Secondary DNS Server	The IP address of the secondary DNS server.

Manually Configure Internet and WAN Settings

78