NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual Protocol Scan Settings on, 195

ProSecure Unified Threat Management (UTM) Appliance

Note: For information about web protocols and ports, see Customize Web

Protocol Scan Settings on page 210.

Figure 108.

2.In the Email section of the screen, select the protocols to scan by selecting the Enable check boxes, and enter the port numbers if different from the default port numbers:

•SMTP. Simple Mail Transfer Protocol (SMTP) scanning is enabled by default on port 25.

•POP3. Post Office Protocol 3 (POP3) scanning is enabled by default on port 110.

•IMAP. Internet Message Access Protocol (IMAP) scanning is enabled by default on port 143.

IMPORTANT:

To enable scanning of encrypted emails, you need to configure the SSL settings (see Configure HTTPS Scanning and SSL Certificates on page 228).

3.If a protocol uses a port other than the standard service port (for example, port 25 for SMTP), enter this nonstandard port in the Ports to Scan field. For example, if the SMTP service on your network uses both port 25 and port 2525, enter both port numbers in the Ports to Scan field and separate them by a comma.

The following protocols are not supported by the UTM:

•SMTP over SSL using port number 465

•POP3 over SSL using port number 995

•IMAP over SSL using port number 993

4.Click Apply to save your settings.

Content Filtering and Optimizing Scans

195