NETGEAR UTM5EW-100NAS manual VPN client IPSec configuration settings Mode Config, 324, Enter

ProSecure Unified Threat Management (UTM) Appliance

Note: This is the name for the IPSec configuration that is used only for the VPN client, not during IPSec negotiation. You can view and change this name in the tree list pane. This name needs to be a unique name.

The IPSec pane displays in the Configuration Panel screen, with the IPSec tab selected by default.

Figure 191.

3.Specify the settings that are explained in the following table.

Table 81. VPN client IPSec configuration settings (Mode Config)

Setting	Description
VPN Client address	This field is masked out because Mode Config is selected. After an IPSec
	connection is established, the IP address that is issued by the UTM displays in this
	field (see Figure 196 on page 328).
Address Type	Select Subnet address from the drop-down list.
Remote host address	The address that you need to enter depends on whether you have specified a LAN
	IP network address in the Local IP Address field on the Add Mode Config Record
	screen of the UTM:
	• If you left the Local IP Address field blank, enter the UTM’s default LAN IP
	address as the remote host address that opens the VPN tunnel. For example,
	enter 192.168.1.1.
	• If you specified a LAN IP network address in the Local IP Address field, enter
	the address that you specified as the remote host address that opens the VPN
	tunnel.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

324