ProSecure Unified Threat Management (UTM) Appliance

Configure Automatic Update and Frequency Settings

To configure the update settings and frequency settings for automatic downloading of the scan engine firmware and pattern file:

1.Locate the Update Settings, Frequency Settings, and HTTPS Proxy Settings sections on the Signatures & Engine screen (see the previous figure), and enter the settings as explained in the following table:

Table 110. Signatures & Engine screen settings

Setting

Description

Update Settings

Update

From the drop-down list, select one of the following options:

 

Never. The pattern and firmware files are not automatically updated.

 

Scan engine and Signatures. The pattern and firmware files are automatically

 

 

updated according to the settings in the Update Frequency section onscreen (see

 

 

explanations later in this table).

Update From Set the update source server by selecting one of the following radio buttons:

Default update server. Files are updated from the default NETGEAR update server.

Server address. Files are updated from the server that you specify. Enter the IP address or host name of the update server in the Server address field.

Update Frequency

Specify the frequency with which the UTM checks for file updates by selecting one of the following radio buttons:

Weekly. From the drop-down lists, select the weekday, hour, and minutes that the updates occur.

Daily. From the drop-down lists, select the hour and minutes that the updates occur.

Every. From the drop-down list, select the frequency with which the updates occur. The range is from 15 minutes to 12 hours.

HTTPS Proxy Settings

Enable

If computers on the network connect to the Internet through a proxy server, select the Enable check box to specify and enable a proxy server. Enter the following settings.

Proxy Server

The IP address and port number of the proxy server.

 

 

User Name

The user name for proxy server authentication.

 

 

Password

The password for proxy server authentication.

 

 

2.Click Apply to save your settings.

Configure Date and Time Service

Configure date, time, and NTP server designations on the System Date & Time screen. Network Time Protocol (NTP) is a protocol that is used to synchronize computer clock times in a network of computers. Setting the correct system time and time zone ensures that the date and time recorded in the UTM logs and reports are accurate.

Network and System Management

456

Page 456
Image 456
NETGEAR UTM5EW-100NAS manual Configure Date and Time Service, Configure Automatic Update and Frequency Settings, 456