NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual Add Static Route screen settings, 122

ProSecure Unified Threat Management (UTM) Appliance

Figure 64.

3.Enter the settings as explained in the following table:

Table 24. Add Static Route screen settings

Setting	Description
Route Name	The route name for the static route (for purposes of identification and
	management).
Active	To make the static route effective, select the Active check box.
	Note: A route can be added to the table and made inactive if not needed. This
	allows you to use routes as needed without deleting and re-adding the entry. An
	inactive route is not advertised if RIP is enabled.
Private	If you want to limit access to the LAN only, select the Private check box. Doing so
	prevents the static route from being advertised in RIP.
Destination IP Address	The destination IP address of the host or network to which the route leads.
IP Subnet Mask	The IP subnet mask of the host or network to which the route leads. If the
	destination is a single host, enter 255.255.255.255.
Interface	From the drop-down list, select the interface that is the physical network interface
	(a WAN interface, LAN, or DMZ for the multiple WAN port models; WAN, LAN, or
	DMZ for the single WAN port models) or virtual interface (VLAN profile) through
	which the route is accessible.
Gateway IP Address	The gateway IP address through which the destination host or network can be
	reached.
Metric	The priority of the route. Select a value between 2 and 15. If multiple routes to the
	same destination exist, the route with the lowest metric is used.

4.Click Apply to save your settings. The new static route is added to the Static Routes table.

LAN Configuration

122