NETGEAR UTM5EW-100NAS Manually Add or Edit a VPN Policy,  To delete one or more VPN polices, 302

ProSecure Unified Threat Management (UTM) Appliance

To delete one or more VPN polices:

1.Select the check box to the left of each policy that you want to delete, or click the Select All table button to select all VPN policies.

2.Click the Delete table button.

To enable or disable one or more VPN policies:

1.Select the check box to the left of each policy that you want to enable or disable, or click the Select All table button to select all VPN policies.

2.Click the Enable or Disable table button.

For information about how to add or edit a VPN policy, see Manually Add or Edit a VPN Policy on this page.

Note: You can delete or edit an IKE policy for which the VPN policy is active without first disabling or deleting the VPN policy. In earlier firmware releases of the UTM, you first had to disable or delete the VPN policy, but this restriction has been removed.

Manually Add or Edit a VPN Policy

To add a VPN policy manually:

1.Select VPN > IPSec VPN > VPN Policies. The VPN Policies screen displays (see Figure 181 on page 301).

2.Under the List of VPN Policies table, click the Add table button. The Add VPN Policy screen displays (see the following figure, which shows the UTM50 screen). The WAN drop-down list (next to Select Local Gateway) is shown on the Add VPN Policy screen for the multiple WAN port models but not on the Add VPN Policy screen for the single WAN port models.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

302