NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual Manage Routing, Configure Static Routes, 121

ProSecure Unified Threat Management (UTM) Appliance

Manage Routing

•Configure Static Routes

•Configure Routing Information Protocol

•Static Route Example

Static routes provide additional routing information to your UTM. Under normal circumstances, the UTM has adequate routing information after it has been configured for Internet access, and you do not need to configure additional static routes. You should configure static routes only for unusual cases such as multiple firewalls or multiple IP subnets on your network.

Note: The UTM automatically sets up routes between VLANs and secondary IP addresses that you have configured on the LAN Multi-homing screen

(see Configure Multihome LAN IP Addresses on the Default VLAN on

page 109). Therefore, you do not need to add a static route manually between a VLAN and a secondary IP address.

Configure Static Routes

To add a static route to the Static Route table:

1. Select Network Config > Routing. The Routing screen displays:

Figure 63.

2.Click the Add table button under the Static Routes table. The Add Static Route screen displays:

LAN Configuration

121