NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual Configure Protocol Binding Optional, 568

ProSecure Unified Threat Management (UTM) Appliance

•Round-robin. With round-robin load balancing, new traffic connections are sent over a DSL, USB, or WAN link in a serial method irrespective of bandwidth or link speed. For example if the DSL, WAN1, and WAN2 interfaces are active in round-robin load balancing mode, an HTTP request could first be sent over the DSL interface, then a new FTP session could start on the WAN1 interface, and then any new connection to the Internet could be made on the WAN2 interface. This load-balancing method ensures that a single interface does not carry a disproportionate distribution of sessions.

3.Click Apply to save your settings.

Configure Protocol Binding (Optional)

To configure protocol binding and add protocol binding rules:

1.Select Network Config > Protocol Binding. The Protocol Bindings screen displays. (The following figure shows two examples in the Protocol Bindings table.)

Figure 333.

The Protocol Bindings table displays the following fields:

•Check box. Allows you to select the protocol binding rule in the table.

•Status icon. Indicates the status of the protocol binding rule:

-Green circle. The protocol binding rule is enabled.

-Gray circle. The protocol binding rule is disabled.

•Service. The service or protocol for which the protocol binding rule is set up.

•Local Gateway. The WAN interface to which the service or protocol is bound.

•Source Network. The computers on your network that are affected by the protocol binding rule.

•Destination Network. The Internet locations (based on their IP address) that are covered by the protocol binding rule.

•Action. The Edit button provides access to the Edit Protocol Binding screen for the corresponding service.

2.Click the Add table button below the Protocol Bindings table. The Add Protocol Binding screen displays:

xDSL Network Module for the UTM9S and UTM25S

568