NETGEAR STM150EW-100NAS, UTM5EW-100NAS Detailed Status screen fields, 495, LAN Port Configuration

ProSecure Unified Threat Management (UTM) Appliance

The following table explains the fields of the Detailed Status screen:

Table 127. Detailed Status screen fields

Item Description

LAN Port Configuration

The following fields are shown for each of the LAN ports.

VLAN Profile	The name of the VLAN profile that you assigned to this port on the LAN Setup
	screen (see Assign and Manage VLAN Profiles on page 100). If the VLAN is not
	enabled on this port, the default profile (with VLAN ID 1) is assigned automatically.
VLAN ID	The VLAN ID that you assigned to this port on the Add VLAN Profile screen (see
	Configure a VLAN Profile on page 103). If the default VLAN profile is used, the
	VLAN ID is 1, which means that all tagged and untagged traffic can pass on this
	port.
MAC Address	The MAC address of this port. All LAN ports share the same MAC address if they
	are part of the default VLAN. However, if LAN port 4 (UTM5, UTM10, UTM25, and
	UTM150) or LAN port 6 (UTM50) is enabled as the DMZ port, its MAC address is
	changed to the MAC address of the WAN2 interface plus 1. (For example, if the
	MAC address of the WAN2 interface is 00:26:f2:b5:db:80, the MAC address of the
	DM port is 00:26:f2:b5:db:81.) For information about configuring the DMZ port, see
	Configure and Enable the DMZ Port on page 117.
IP Address	The IP address for this port. If the VLAN is not enabled on this port, the IP address
	is the default LAN IP address (192.168.1.1). For information about configuring
	VLAN profiles, see Configure a VLAN Profile on page 103.
Subnet Mask	The subnet mask for this port. If the VLAN is not enabled on this port, the subnet
	mask is the default LAN IP subnet mask (255.255.255.0). For information about
	configuring VLAN profiles, see Configure a VLAN Profile on page 103.
DHCP Status	The status can be either DHCP Enabled or DHCP Disabled. For information about
	enabling DHCP for this port, see Configure a VLAN Profile on page 103.

WAN Info, xDSL information in SLOT-1 Info or SLOT-2 Info, and USB Info

Note: For the UTM9S and UTM25S only: DSL information is shown in the SLOT-1 Info or SLOT-2 Info section, depending on the slot in which the xDSL network module is installed. All other fields that are shown in the SLOT-1 Info or SLOT-2 Info section are also shown in the WAN Info sections.

Note: The USB information in the USB Info section applies to the UTM9S and UTM25S only.

The following fields are shown for each of the WAN ports and for the slot in which the xDSL network module is installed:

WAN Mode	The WAN mode can be Single Port, Load Balancing, or Auto Rollover. For
	information about configuring the WAN mode, see Configure the WAN Mode on
	page 80.
Card Type (UTM9S and	The configuration of the xDSL network module: VDSL or ADSL.
UTM25S only)
Daughter Card (UTM9S	The type of supported annex on the xDSL network module: Annex A or Annex B
and UTM25S only)	(VDSL_ANNEXA, VDSL_ANNEXB, ADSL_ANNEXA, or ADSL_ANNEXB).

Monitor System Access and Performance

495