NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual 575

ProSecure Unified Threat Management (UTM) Appliance

Note: You can also configure the failure detection method for the auto-rollover mode on the Advanced Options screen for the DSL interface. This procedure is discussed in Configure the Failure Detection Method on page 565.

IMPORTANT:

Each computer or router on your network has a unique 48-bit local Ethernet address. This is also referred to as the computer’s Media Access Control (MAC) address. The default, on the WAN Advanced Options screen, is Use Default Address. If your ISP requires MAC authentication and another MAC address has been previously registered with your ISP, then you need to enter that address on the Advanced Options screen for the DSL interface.

To configure advanced WAN options:

1.Select Network Config > WAN Settings.

2.Click the Edit button in the Action column of the SLOT-x entry. The SLOT-x ISP Settings screen displays (see Figure 323 on page 554, which shows the SLOT-2 ISP Settings screen as an example).

3.Click the Advanced option arrow in the upper right of the screen. The SLOT-x Advanced Options screen displays. (The following figure shows the SLOT-2 Advanced Options screen as an example.)

Figure 338.

xDSL Network Module for the UTM9S and UTM25S

575