NETGEAR STM150EW-100NAS manual IPSec VPN Wizard settings for a client-to-gateway tunnel, 273, Fqdn

ProSecure Unified Threat Management (UTM) Appliance

To display the wizard default settings, click the VPN Wizard default values option arrow in the upper right of the screen. A pop-up screen displays (see Figure 153 on page 268), showing the wizard default values.

The VPN Wizard default values screen lists some incorrect default values. The correct values are listed in the following table.

Table 63. IPSec VPN Wizard default values for a client-to-gateway tunnel

Setting	Default Value
IKE policy
Exchange mode	Aggressive
ID type	FQDN
Local WAN ID	utm_local1.com
Remote WAN ID	utm_remote1.com
Encryption algorithm	3DES
Authentication algorithm	SHA-1
Authentication method	Pre-shared Key
Key group	DH-Group 2 (1024 bit)
Life time	8 hours
VPN policy
Encryption algorithm	3DES
Authentication algorithm	SHA-1
Life time	1 hour
Key group	DH-Group 2 (1024 bit)
NetBIOS	Disabled

2.Select the radio buttons and complete the fields and as explained in the following table:

Table 64. IPSec VPN Wizard settings for a client-to-gateway tunnel

Setting	Description
About VPN Wizard
This VPN tunnel will connect	Select the VPN Client radio button. The default remote FQDN
to the following peers	(utm_remote.com) and the default local FQDN (utm_local.com) display in the
	End Point Information section of the screen.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

273