NETGEAR STM150EW-100NAS manual IPSec VPN Wizard settings for a gateway-to-gateway tunnel, 269

ProSecure Unified Threat Management (UTM) Appliance

Table 61. IPSec VPN Wizard default values for a gateway-to-gateway tunnel (continued)

Setting	Default Value
Key group	DH-Group 2 (1024 bit)
NetBIOS	Enabled

2.Select the radio buttons and complete the fields and as explained in the following table:

Table 62. IPSec VPN Wizard settings for a gateway-to-gateway tunnel

Setting	Description
About VPN Wizard
This VPN tunnel will connect	Select the Gateway radio button. The local WAN port’s IP address or
to the following peers	Internet name displays in the End Point Information section of the screen.
This VPN tunnel will use	Select a WAN interface from the drop-down list to specify which local WAN
following local WAN Interface	interface the VPN tunnel uses as the local endpoint.
(multiple WAN port models
	Select the Enable RollOver? check box to enable VPN rollover, and then
only)
	select a WAN interface from the drop-down list to the right of the check box
	to specify the interface to which the VPN rollover should occur.
	Note: If the multiple WAN port model is configured to function in WAN
	auto-rollover mode, you can use the VPN Wizard to configure VPN rollover
	and do not need to configure this manually.
Connection Name and Remote IP Type
What is the new Connection	Enter a descriptive name for the connection. This name is used to help you
Name?	to manage the VPN settings; the name is not supplied to the remote VPN
	endpoint.
What is the pre-shared key?	Enter a pre-shared key. The key needs to be entered both here and on the
	remote VPN gateway. This key needs to have a minimum length of
	8 characters and should not exceed 49 characters.
End Point Informationa
What is the Remote WAN’s IP	Enter the IP address or Internet name (FQDN) of the WAN interface on the
Address or Internet Name?	remote VPN tunnel endpoint.
What is the Local WAN’s IP	When you select the Gateway radio button in the About VPN Wizard
Address or Internet Name?	section of the screen, the IP address of the UTM’s active WAN interface is
	automatically entered.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

269