NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual Setting Description LAN TCP/IP Setup, Dhcp

ProSecure Unified Threat Management (UTM) Appliance

Table 4. Setup Wizard Step 1: LAN Settings screen settings

Setting	Description
LAN TCP/IP Setup
IP Address	Enter the IP address of the UTM’s default VLAN (the factory default address is
	192.168.1.1).
	Note: Always make sure that the LAN port IP address and DMZ port IP address are in
	different subnets.
	Note: If you change the LAN IP address of the UTM’s default VLAN while being
	connected through the browser, you are disconnected. You then need to open a new
	connection to the new IP address and log in again. For example, if you change the
	default IP address from 192.168.1.1 to 10.0.0.1, you now need to enter https://10.0.0.1
	in your browser to reconnect to the web management interface.
Subnet Mask	Enter the IP subnet mask. The subnet mask specifies the network number portion of an
	IP address. The UTM automatically calculates the subnet mask based on the IP
	address that you assign. Unless you are implementing subnetting, use 255.255.255.0
	as the subnet mask (computed by the UTM).
DHCP
Disable DHCP Server	If another device on your network is the DHCP server for the default VLAN, or if you will
	configure the network settings of all of your computers manually, select the Disable
	DHCP Server radio button to disable the DHCP server. By default, this radio button is
	not selected, and the DHCP server is enabled.
Enable DHCP Server	Select the Enable DHCP Server radio button to enable the UTM to function as a
	Dynamic Host Configuration Protocol (DHCP) server, providing TCP/IP configuration
	for all computers connected to the default VLAN. Enter the following settings.
	Domain Name	This setting is optional. Enter the domain name of the UTM.
	Starting IP	Enter the starting IP address. This address specifies the first of the
	Address	contiguous addresses in the IP address pool. Any new DHCP client
		joining the LAN is assigned an IP address between this address and
		the ending IP address. The IP address 192.168.1.2 is the default
		starting address.
	Ending IP	Enter the ending IP address. This address specifies the last of the
	Address	contiguous addresses in the IP address pool. Any new DHCP client
		joining the LAN is assigned an IP address between the starting IP
		address and this IP address. The IP address 192.168.1.100 is the
		default ending address.
		Note: The starting and ending DHCP IP addresses should be in the
		same network as the LAN TCP/IP address of the UTM (that is, the IP
		address in the LAN TCP/IP Setup section as described earlier in this
		table).

Use the Setup Wizard to Provision the UTM in Your Network

49