NETGEAR STM150EW-100NAS Configure a Vlan Profile, Ldap Server,  To add or edit a Vlan profile

ProSecure Unified Threat Management (UTM) Appliance

configuration in auto-rollover mode with route diversity (that is, with two different ISPs) and you cannot ensure that the DNS server is available after a rollover has occurred.

LDAP Server

A Lightweight Directory Access Protocol (LDAP) server allows a user to query and modify directory services that run over TCP/IP. For example, clients can query email addresses, contact information, and other service information using an LDAP server. For each VLAN, you can specify an LDAP server and a search base that defines the location in the directory (that is, the directory tree) from which the LDAP search begins.

Configure a VLAN Profile

For each VLAN on the UTM, you can configure its profile, port membership, LAN TCP/IP settings, DHCP options, DNS server, and inter-VLAN routing capability.

The preconfigured default VLAN is called defaultVLAN.

To add or edit a VLAN profile:

1.Select Network Config > LAN Settings. The LAN submenu tabs display, with the LAN Setup screen in view. The following figure shows the LAN Setup screen for the UTM25 with four LAN ports, and the default VLAN profile and another VLAN profile as examples. Note that the LAN Setup screen for the UTM50 (not shown in this manual) has six LAN ports in the Default VLAN section.

Note: For information about how to manage VLANs, see Port-Based VLANs on page 99. The following information describes how to configure a VLAN profile.

Figure 55.

LAN Configuration

103