NETGEAR UTM5EW-100NAS Setup Wizard WAN Settings screen settings, Setting Description ISP Login

ProSecure Unified Threat Management (UTM) Appliance

Enter the settings as explained in the following table, and then click Next to go the following screen.

Note: Instead of manually entering the settings, you can also click the Auto Detect action button at the bottom of the screen. The autodetect process probes the WAN port for a range of connection methods and suggests one that your ISP is most likely to support.

Table 5. Setup Wizard Step 2: WAN Settings screen settings

Setting	Description
ISP Login
Does your Internet	If you need to enter login information every time you connect to the Internet through
connection require a	your ISP, select the Yes radio button. Otherwise, select the No radio button, which is
login?	the default setting, and skip the ISP Type section. If you select the Yes radio button,
	enter the following settings.
	Login	The login name that your ISP has assigned to you.
	Password	The password that your ISP has assigned to you.
ISP Type
What type of ISP	If your connection is PPPoE or PPTP, then you need to log in. Select the Yes radio
connection do you	button. Based on the connection that you select, the text fields that require data entry
use?	are highlighted. If your ISP has not assigned any login information, then select the No
	radio button and skip this section. If you select the Yes radio button, enter the following
	settings.
Austria (PPTP)	If your ISP is Austria Telecom or any other ISP that uses PPTP for login, select this
	radio button and enter the following settings:
	Account Name	The account name is also known as the host name or system
		name. Enter the valid account name for the PPTP connection
		(usually your email ID assigned by your ISP). Some ISPs
		require you to enter your full email address here.
	Domain Name	Your domain name or workgroup name assigned by your ISP,
		or your ISP’s domain name. You can leave this field blank.
	Idle Timeout	Select the Keep Connected radio button to keep the
		connection always on. To log out after the connection is idle
		for a period:
		1. Select the Idle Timeout radio button.
		2. In the time-out field, enter the number of minutes to wait
		before disconnecting.
		This is useful if your ISP charges you based on the period that
		you are logged in.

Use the Setup Wizard to Provision the UTM in Your Network

52