NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual VPN client authentication settings Mode Config, 322

ProSecure Unified Threat Management (UTM) Appliance

4.Specify the settings that are explained in the following table.

Table 79. VPN client authentication settings (Mode Config)

Setting	Description
Interface	Select Any from the drop-down list.
Remote Gateway	Enter the remote IP address or DNS name of the UTM. For example, enter
	10.34.116.22.
Preshared Key	Select the Preshared Key radio button. Enter the pre-shared key that you already
	specified on the UTM. For example, enter H8!spsf3#JYK2!. Confirm the key in the
	Confirm field.
IKE	Encryption	Select the 3DES encryption algorithm from the drop-down list.
	Authentication	Select the SHA1 authentication algorithm from the drop-down list.
	Key Group	Select the DH2 (1024) key group from the drop-down list.
		Note: On the UTM, this key group is referred to as Diffie-Hellman
		Group 2 (1024 bit).

5.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

6.Click the Advanced tab in the Authentication pane. The Advanced pane displays.

Figure 190.

Virtual Private Networking Using IPSec, PPTP, or L2TP Connections

322