NETGEAR UTM5EW-100NAS, STM150EW-100NAS manual 132, Service Profiles on

ProSecure Unified Threat Management (UTM) Appliance

Table 27. Outbound rules overview (continued)

Setting	Description	Outbound Rules
QoS Profile	The priority assigned to IP packets of this service. The priorities are	LAN WAN rules
	defined by Type of Service (ToS) in the Internet Protocol Suite	DMZ WAN rule
	standards, RFC 1349. The QoS profile determines the priority of a
	service, which, in turn, determines the quality of that service for the
	traffic passing through the firewall.
	The UTM marks the Type of Service (ToS) field as defined in the QoS
	profiles that you create. For more information, see Create Quality of
	Service Profiles on page 169.
	Note: There is no default QoS profile on the UTM. After you have
	created a QoS profile, it can become active only when you apply it to
	a nonblocking inbound or outbound firewall rule.
	Note: This field is not applicable to LAN DMZ rules.
Log	The settings that determine whether packets covered by this rule are	All rules
	logged. The options are:
	• Always. Always log traffic considered by this rule, whether it
	matches or not. This is useful when you are debugging your rules.
	• Never. Never log traffic considered by this rule, whether it
	matches or not.
Bandwidth Profile	Bandwidth limiting determines how the data is sent to and from your	LAN WAN rules
	host. The purpose of bandwidth limiting is to provide a solution for
	limiting the outgoing and incoming traffic, thus preventing the LAN
	users from consuming all the bandwidth of the Internet link. For more
	information, see Create Bandwidth Profiles on page 171. Bandwidth
	limiting occurs in the following ways:
	• For outbound traffic. On the available WAN interface in the
	primary WAN mode and auto-rollover mode, and on the selected
	interface in load balancing mode.
	• For inbound traffic. On the LAN interface for all WAN modes.
	Note: Bandwidth limiting does not apply to the DMZ interface.
Traffic Meter Profile	Select a traffic meter profile to measure and control traffic that is	LAN WAN rules
	downloaded, uploaded, or both. The traffic meter profile applies only to	DMZ WAN rule
	traffic that is covered by this rule. Depending on the configuration of
	the traffic meter profile, when traffic has reached its configured limit,
	traffic is either logged or blocked. For information about creating traffic
	meter profiles, see Create Traffic Meter Profiles on page 174.
	Note: You cannot assign traffic meter profiles to LAN DMZ firewall
	rules.

Firewall Protection

132