ProSecure Unified Threat Management (UTM) Appliance

To create an inbound DMZ WAN service rule:

1.In the DMZ WAN Rules screen, click the Add table button under the Inbound Services table. The Add DMZ WAN Inbound Service screen displays:

Figure 72.

2.Enter the settings as explained in Table 28 on page 135.

3.Click Apply to save your changes. The new rule is now added to the Inbound Services table.

Configure LAN DMZ Rules

Create LAN DMZ Outbound Service Rules

Create LAN DMZ Inbound Service Rules

The LAN DMZ Rules screen allows you to create rules that define the movement of traffic between the LAN and the DMZ. The default outbound and inbound policies are to block all traffic between the local LAN and DMZ network. You can then apply firewall rules to allow specific types of traffic either going out from the LAN to the DMZ (outbound) or coming in from the DMZ to the LAN (inbound).

There is no drop-down list that lets you set the default outbound policy as there is on the LAN WAN Rules screen. You can change the default outbound policy by allowing all outbound traffic and then blocking specific services from passing through the UTM. You do so by adding outbound service rules (see Create LAN DMZ Outbound Service Rules on page 147).

Firewall Protection

145

Page 145
Image 145
NETGEAR STM150EW-100NAS, UTM5EW-100NAS manual Configure LAN DMZ Rules,  To create an inbound DMZ WAN service rule, 145