Press the ENTER AGE/WT button again to
9 check for system errors.
If there are no system errors, the words NO SYS- TEM ERRORS will appear in the main display. If the words LUBRICATE DECK appear in the main display, the walking platform should be checked for adequate lubricant. Follow the instructions in step 4 on page 29 to lubricate the walking platform if necessary. Then, refer to HOW TO RESET THE LUBE REMINDER on page 25.
Press the ENTER AGE/WT button again and
10 enable or disable the lubrication reminder.
The console can be set to display the words LU- BRICATE DECK every five minutes when the walking platform needs to be lubricated. Press the
+or – button above the ENTER AGE/WT button until the words LUBE REMINDER ENABLED ap- pear in the main display. To turn off the lubrication reminder, press the + or – button until the words LUBE REMINDER DISABLED appear.
11 | Press the ENTER AGE/WT button again and |
enable or disable the safety key. |
To require the use of the safety key with the con- sole, press the + or – button above the ENTER AGE/WT button until the words SAFETY KEY EN- ABLED appear in the main display. To allow the treadmill to be used without the key, press the + or
–button until the words SAFETY KEY DISABLED appear.
If you have the Basic console, go to step 16. If you have the Workout TV console, go to step 12.
12 | Press the ENTER AGE/WT button again and |
enable or disable the TV. |
To make the TV available for use, press the + or – button above the ENTER AGE/WT button until the words TV POWER ON appear in the main display.
To prevent the TV from being used, press the + or
– button until the words TV POWER OFF appear.
If you have disabled the TV, go to step 16. If you have enabled the TV, go to step 13.
Press the ENTER AGE/WT button again and
13 select a cable TV connection or an antenna connection.
If you are using a cable TV connection, press the +
or – button beside the ENTER AGE/WTbutton until the words TV MODE CABLE STATIONS ap-
pear in the main display. If you are using an an- tenna connection, press the + or – button until the words TV MODE AIR STATIONS appear.
14 | Press the ENTER AGE/WT button again and |
program TV channels. |
The console has the capability to find and store in memory all of the valid TV channels in your area. While the words PRESS CHANNEL UP TO SCAN TV CHANNELS are scrolling across the main dis- play, press the CHANNEL + button to start the channel scanning process.
The console will begin scanning all TV channels. If no broadcast signal is detected on a channel, the channel will be skipped; if a signal is detected, a tone will sound and the channel will be stored in memory. This process will continue until the high- est channel is reached. The lowest channel stored in memory will then appear in the main display.
24
