P REVENTIVE | M AINTENANCE |
Regular maintenance is necessary for optimal performance and long treadmill life. Please read and follow all instructions below. If the treadmill is not maintained as described, components may wear excessively
and the treadmill may be damaged.If you have questions about maintenance, please contact your distributor.
CAUTION: Make sure to remove the key and unplug the power cord before performing any maintenance procedures.
WEEKLY MAINTENANCE
1.Inspect and properly tighten all external parts of the treadmill.
2.Apply a mild
ing belt. | Do not wipe under the walking belt. | Apply a small amount of mild | |
cotton cloth and wipe | the console and the screens. | Do not spray cleaner directly onto the treadmill or use | |
ammonia or | cleaners. |
| |
3.Make sure that the walking belt is centered and properly tightened. If it is centered and runs smoothly, do not make any adjustments. If the walking belt needs to be adjusted, refer to pages 33 and 34.
MONTHLY MAINTENANCE
1. Remove the two screws attaching the motor hood and lift off
the motor hood. Using a
covered by the motor hood.Be careful to avoid touchingMotor Belt
any components.
2.Check the motor belt for wear and cracks. If the motor belt needs to be replaced, refer to page 42 to order a new motor
belt. |
|
|
|
|
|
|
3. Plug in the power cord and insert the key into the console. |
|
|
| |||
Press the START button. | Be careful to avoid injury; keep |
|
|
| ||
your hands away from moving parts and make sure that |
|
|
| |||
your clothing cannot become caught in moving parts. |
| While the walking belt is moving, check the motor |
| |||
for arcing. Next, check the treadmill for unusual noises or odors. If any of these problems exists, contact your |
| |||||
distributor. | Remove the key and unplug the power cord. |
| Reattach the motor hood with the two screws. |
| ||
4. The walking platform should | not | be lubricated before the |
|
|
| |
treadmill is used. However, lubricant should be applied at |
|
| B | |||
least once per month. To purchase a lubricant pump or lubri- |
|
| ||||
|
|
| ||||
cant packets, contact your distributor. | CAUTION: Before ap- |
|
| |||
plying lubricant, remove the key and unplug the power |
|
|
| |||
cord. |
|
|
|
|
|
|
To use a lubricant pump, | first prime the pump. Insert the |
| A | Apply | ||
| packet | |||||
wand under the walking belt in the location shown by dotted |
|
| ||||
|
| here | ||||
line A. Center the nozzles under the walking belt and apply |
|
| ||||
|
|
| ||||
lubricant as you slide the wand forward to dotted line B. Then, |
| Insert wand |
| |||
pull the wand back out. | To use lubricant packets, | open one | here |
| ||
packet, reach under one side of the walking belt as far as you |
|
|
| |||
can, and apply the entire packet between dotted line A and |
|
|
| |||
dotted line B. Then, apply a second packet under the other side of the walking belt in the same way. | After you | |||||
have applied lubricant using a lubricant pump or lubricant packets, plug in the power cord, insert the |
| |||||
key, adjust the speed to 5 kph, and walk on the walking belt for two minutes to spread the lubricant. |
| |||||
29
