HP Laser M602, Laser M603 Link speed and duplex settings, Setting Description Auto, 100TX Auto

Link speed and duplex settings

The link speed and communication mode of the print server must match the network. For most situations, leave the product in Auto mode. Incorrect changes to the link speed and duplex settings might prevent the product from communicating with other network devices. If you need to make changes, use the product control panel.

NOTE: Making changes to these settings causes the product to turn off and then on. Make changes only when the product is idle.

1.At the control panel, press the Home button.

2.Open each of the following menus:

a.Administration

b.Network Settings

c.Jetdirect Menu

d.Link Speed

3.Select one of the following options.

Setting		Description
Auto		The print server automatically configures itself for the highest link speed and
		communication mode allowed on the network.
10T	Half	10 megabytes per second (Mbps), half-duplex operation
10T	Full	10 Mbps, full-duplex operation
100TX Half		100	Mbps, half-duplex operation
100TX Full		100	Mbps, full-duplex operation
100TX Auto		Limits auto-negotiation to a maximum link speed of 100 Mbps
1000T Full		1000 Mbps, full-duplex operation

4.Press the OK button. The product turns off and then on.

68 Chapter 5 Connect the product with Windows ENWW