Manually configure IPv4 TCP/IP parameters from the control panel

Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and default gateway.

1.At the control panel, press the Home button.

2.Open each of the following menus:

a.Administration

b.Network Settings

c.Jetdirect Menu

d.TCP/IP

e.IPV4 Settings

f.Config Method

g.Manual

h.Manual Settings

i.IP Address, Subnet Mask, or Default Gateway

3.Use the numeric keypad, or press the up arrow or the down arrow to increase or decrease the number for the first byte of the IP address, subnet mask, or default gateway.

4.Press the OK button to move to the next set of numbers. To move to the previous set of numbers, press the back arrow .

5.Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then press the OK button to save the setting.

66

Chapter 5 Connect the product with Windows

ENWW

Page 82
Image 82
HP Laser M603, Laser M602, Laser M601 manual Enww