Brother NX 200 manual Error messages, You wish to sew Wish to sew, Pressure of the presser foot is

Symptom	Probable Cause	Remedy	Reference
	The feed dogs are lowered.	Slide the drop feed lever to the left.	page 67, 81
	The stitch is too fine.	Lengthen the stitch length.	page 46
	The presser foot that is used is not	Attach the presser foot that is appro-
	appropriate for the type of stitch that	priate for the type of stitch that you	page 92
The fabric does	you wish to sew.	wish to sew.
not feed.	The pressure of the presser foot is	Turn the presser foot pressure dial to
		the right to increase the pressure of	page 30
	weak.
		the presser foot.
	The thread is tangled, for example,	Remove the tangle thread. If the
		thread is tangled in the shuttle, clean	page 96
	in the shuttle.
		the shuttle.
The sewing lamp	The sewing lamp is damaged.	Contact your retailer or the nearest	–
does not come on.		authorized service center.

Error messages

If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed

incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear.

If you press (Stitch selection key) or do the operation correctly while the error message is displayed, the message disappears.

Error Message Probable Cause

The start/stop button or reverse/reinforcement stitch but- ton was pressed while the presser foot was raised.

A stitch other than the buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is lowered.

The buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is raised.

The reverse/reinforcement stitch button or needle posi- tion button was pressed while the bobbin winder shift is moved to the right.

The start/stop button was pressed while the foot control- ler was connected.

The motor locked up because the thread is tangled.

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Troubleshooting 101