Brother NX 200 manual 4Slide the bobbin winder shaft to the right

1Turn on the sewing machine.

2Lift open the upper cover.

3Place the bobbin on the bobbin winder shaft so that the spring on the shaft fits into the notch in the bobbin.

1

2

1Notch

2Bobbin winder shaft spring

4Slide the bobbin winder shaft to the right.

5Removespool pin.the spool cap that is inserted onto the

1

2

1Spool pin

2 Spool cap

6Place the spool of thread for the bobbin onto the spool pin.

Slide the spool onto the pin so that the spool is horizontal and the thread unrolls from the bottom front of the spool.

•If the spool is not positioned so that the thread unrolls correctly, the thread may become tangled around the spool pin.

7Slide the spool cap onto the spool pin. With the rounded side of the spool cap positioned toward the left, slide the spool cap onto the spool pin as far as possible until the right side of the spool touches the right end of the spool pin.

• Three spool cap sizes are available (large, medium and small). Use the spool cap with a diameter that is slightly larger than the diameter of the spool. The medium-sized spool cap is already on the spool pin when the sewing machine is purchased.

1 2

3

1Spool cap (large)

2 Spool cap (medium)

3 Spool

•When using a spool of cross-wound thread, install the small spool cap with some space between the cap and the spool.

1

2

3

1Spool

2 Gap

3 Spool cap (small)

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Winding/Installing the Bobbin 13