Brother NX 200 manual Removing the presser foot holder, Using the optional walking foot

Removing the presser foot holder

Remove the presser foot holder when cleaning the sewing machine or when installing a presser foot that does not use the presser foot holder, such as the quilting foot. Use the screwdriver to remove the presser foot holder.

■Removing the presser foot holder

1Remove the presser foot.

•For details, refer to “Replacing the presser foot” (page 29).

2Useholderthescrew.screwdriver to loosen the presser foot

1

1Screwdriver

■Attaching the presser foot holder

1Align the presser foot holder with the lower- left side of the presser bar.

2Hold the presser foot holder in place with your right hand, and then tighten the screw using the screwdriver in your left hand.

1

1Screwdriver

Note

●If the presser foot holder is not correctly installed, the thread tension will be incorrect.

Using the optional walking foot

With the walking foot, both pieces of fabric are fed evenly by the feed dogs and the teeth on the presser foot. This is useful when sewing fabrics that are hard to feed such as vinyl and leather and when sewing fabrics that easily slip such as velvets or when quilting.

Use the screwdriver to attach the walking foot.

■Attaching the walking foot

1Remove the presser foot holder.

•For details, refer to “Removing the presser foot holder” (at the left).

2Hook the connecting fork of the walking foot onto the needle clamp screw.

1

2

1Connecting fork

2 Needle clamp screw

3Lower the presser foot lever, insert the presser foot holder screw, and then tighten the screw with the screwdriver.

1

1Presser foot holder screw

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Replacing the Presser Foot 31