Brother NX 200 manual Adjusting the pressure of the presser foot, Presser foot is attached

GETTING READY ———————————————————————————————————————————————————

5Place a different presser foot below the holder so that the presser foot pin is aligned with the notch in the holder.

Position the presser foot so the letter indicating the presser foot type (A, G, I, J, M, N or R) is positioned to be read.

1

23

1Presser foot holder

2 Notch

3 Pin

6Slowly lower the presser foot lever so that the presser foot pin snaps into the notch in the presser foot holder.

1

1Presser foot lever

XThe presser foot is attached.

7Raise the presser foot lever to check that the presser foot is securely attached.

Note

●For details on the presser foot that should be used with the selected stitch, refer to “Stitch Settings” (page 92).

Adjusting the pressure of the presser foot

The amount of pressure that the presser foot applies to the fabric can be adjusted.

1Lower the presser foot lever.

1

1Presser foot lever

2Turnsewingthemachine.presser foot dial at the back of the The scale on the dial indicates the range from 1 (weak) to 4 (strong). Turn the dial to the right (smaller number) to decrease the pressure. Turn the dial to the left (large number) to increase the pressure.

Strong 3 Weak

3When you are finished sewing, reset the dial to 3 (standard).

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

30