TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 12). Use only a | ||
sor that meets all of the specifications described on page 12. | IMPORTANT: The treadmill is not | |
compatible with |
|
|
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. | ||
c. Check the reset/off circuit breaker located on the | c |
|
treadmill frame near the power cord. If the switch pro- |
| |
trudes as shown, the circuit breaker has tripped. To |
|
|
reset the circuit breaker, wait for five minutes and | Tripped | Reset |
then press the switch to the reset position. | ||
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console. d. If the treadmill still will not run, see the front cover of this manual.
PROBLEM: The console screen remains lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a | ||||
store. If the screen remains lit when you remove the key, the demo mode is turned on. To turn off | ||||
the demo mode, see step 4 on page 22. |
|
|
|
|
PROBLEM: The console does not display speed and distance correctly |
|
|
| |
SOLUTION: a. Remove the key from the console and unplug the | a |
|
|
|
power cord. Next, remove the #8 x 3/4" Hood | 6 | 73 |
| |
Screws (6) from the Motor Hood (73) and pivot the |
| 6 | ||
Motor Hood off. |
|
|
| |
26
