Lightwave Communications LDX-3232 manual LASerEVEnt?, Las Eve, LASerENABleEVEnt command

C H A P T E R 4

COMMAND REFERENCE

LDX-3232 Device-Dependent Command Reference

LASer:EVEnt?	FRONT PANEL
	REMOTE

The LASer:EVEnt? query returns the value of the status event register of the LASER operations.

Syntax Diagram

: LAS : EVE ?

-where the response is the sum of the following:

1	LASER Current Limit	256	Output is shorted
2	LASER Voltage Limit	512	Output changed to be in/out of tolerance
4	N/A	1024	Output on/off state changed
8	Power limit	2048	Measurement ready
16	Interlock disabled	4096	N/A
32	N/A	8192	N/A
64	Compliance Voltage Limit	16384	N/A
128	Open circuit	32768	N/A
Notes	The LASER conditions that are reported in the status byte can be set by using the
	LASer:ENABle:EVEnt command.
	The LASER event status is only cleared when the event status is read or by the *CLS
	command while the condition status is constantly changing.
Examples	"LAS:EVE?" -response: 513, means that the LASER output tolerance changed and
	current limit events have occurred since the last LASer:EVEnt? query.

"Radix Hex; Laser:Event?" -response: #H88, means that the LASER Power limit and Open circuit events have occurred since the last LASer:EVEnt? query.

60 LDX-3232