Lightwave Communications LDX-3232 LASerDISplayPARAM, LASerDISplaySET, LAS DIS Param, Las Dis Set

COMMAND REFERENCE

LDX-3232 Device-Dependent Command Reference

C H A P T E R 4

LASer:DISplay:PARAM	FRONT PANEL
	REMOTE

The LASer:DISplay:PARAM command enables the display to show the parameter values.

Syntax Diagram

	:	LAS	:	DIS	:	PARAM
Parameters	None
Notes	This command has the same effect as pressing the (PARAMETER) SELECT switch
	while in LASER mode. The selected parameter will be displayed for three seconds. The
	actual LASER PARAM display is turned off automatically when a display selection is
	enabled.
	Each time the command is issued, the next LASER parameter will be selected, see
	Chapter 2 for more information.
Examples	"Laser:Display:Param" -action: selects a parameter and displays its value.

"LAS:DIS:PARAM" -action: selects a parameter and displays its value.

LASer:DISplay:SET	FRONT PANEL
	REMOTE

The LASer:DISplay:SET command sets the display to show the setpoint of the selected display mode.

Syntax Diagram

	:	LAS	:	DIS	:	SET
Parameters	None
Notes	Using this command has the same effect as physically holding the (DISPLAY) SELECT
	switch down continuously.
Examples	"Las:Dis:Set"	-action: enables the display for the setpoint of the selected mode: LDI,

MDI (IPD) or MDP (PPD)

"LAS:Dis:Set" -action: enables the display for the setpoint of the selected display mode.

04_06 LDX-3232 53