Lightwave Communications LDX-3232 Used to create a delay in the execution of further, Commands

COMMAND REFERENCE

C H A P T E R 4

C H A P T E R 4

COMMAND REFERENCE

This chapter is a guide to all of the device-dependent commands for the LDX-3232 High Compliance Current Source. This chapter is divided into two parts. The first part contains an overview of the remote commands used by the LDX-3232 High Compliance Current Source. The second part contains all of the LDX-3232 commands in alphabetical order. Figure 4.1 shows the format for the device command descriptions in this chapter. The commands that emulate local (front panel) operation are denoted by the solid box next to the Local label in the upper left corner of the command description.

Table 4.1 LDX-3232 Series Device-Dependent Commands

Name	Parameters	Function
DELAY	1	Used to create a delay in the execution of further
		commands
ERR?	NONE	Returns errors generated since the last query
LAS:CALMD	1	Used to set the CAL PD (monitor responsivity) constant
LAS:CALMD?	NONE	Returns the CAL PD (monitor responsivity) constant
LAS:CAL:CONST?	1	Factory use only
LAS:CAL:LDI	NONE	Used to enter the laser current calibration mode
LAS:CAL:LDI?	NONE	Returns the ready state for entering the laser current
		calibration value
LAS:CAL:LDV	NONE	Used to enter the laser voltage calibration mode
LAS:CAL:LDV?	NONE	Returns the ready state for entering the laser voltage
		calibration mode
LAS:CAL:MDI	NONE	Used to enter the monitor photodiode current calibration
		mode

04_06 LDX-3232 35