Lightwave Communications LDX-3232 manual Response Message

C H A P T E R 6

CALIBRATION AND TR OU BLESHOOTING

Error Messages

Error Code	Explanation
E-203	Security violation, command is not available without clearance
E-205	<PROGRAM DATA> is not a Boolean value or word
E-207	<PROGRAM DATA> will not convert to an unsigned 16-bit value
E-209	<PROGRAM DATA> will not convert to an unsigned 32-bit value
E-210	<PROGRAM DATA> will not convert to a floating point value
E-211	<PROGRAM DATA> will not convert to a character value
E-213	<PROGRAM DATA> is incorrect block data length
E-214	<PROGRAM DATA> length exceeds maximum

E-302

Query error; device was addressed to talk, but GPIB controller failed to read all of the

<RESPONSE MESSAGE>

E-501	LASER interlock disabled output
E-503	LASER open circuit disabled output
E-504	LASER current limit disabled output
E-505	LASER voltage limit disabled output
E-507	LASER power limit disabled output
E-510	LASER out of tolerance disabled output
E-511	LASER control error disabled output
E-512	Analog section status is all 1’s or all 0’s (power down)
E-513	Serial EEPROM checksum error
E-515	Laser output must be off to change ranges
E-516	Incorrect configuration for calibration sequence to start
E-519	Setting a measurement is only valid during the calibration phase for that measurement;
	user has tried to calibrate a measurement without first entering the required calibration
	mode.

102 LDX-3232