Lightwave Communications LDX-3232 manual LASerENABleCOND?, Bit, LAS Enab Cond

COMMAND REFERENCE

LDX-3232 Device-Dependent Command Reference

C H A P T E R 4

Examples	"LAS:ENAB:COND 129" -action: enables the LASER status condition register so that the
	Open circuit and LASER current limit conditions will be summarized in the status byte
	(bit 3).
	Laser:Enable:Cond #H0F9B" - action: enables the LASER status condition register so
	that any and all of the above conditions will be reported in the status byte register (bit 3).

LASer:ENABle:COND?	FRONT PANEL
	REMOTE

The LASer:ENABle:COND? query returns the value of the status condition enable register of the LASER operations.

Syntax Diagram

: LAS : ENAB : COND ?

- where the response is the sum of the following:

1	LASER Current Limit	256	Output is shorted
2	LASER Voltage Limit	512	Output changed to be in/out of tolerance
4	N/A	1024	Output on/off state
8	Power limit	2048	Ready for calibration data state
16	Interlock disabled	4096	N/A
32	N/A	8192	N/A
64	Compliance Voltage Limit	16384	N/A
128	Open circuit	32768	N/A
Notes	The enabled LASER conditions can be set by using the LASer:ENABle:COND
	command.
	The LASER condition status can be monitored by the LASer:COND? query.
Examples	"LAS:ENAB:COND?" -response: 17, means that the Laser Current Limit and Interlock
	disabled LASER conditions will be reported (in summarized form) to the status byte
	(bit 3).

"Radix Hex; Laser:Enable:Cond?" -response: #H0F9B, means that all of the above conditions will be reported (in summarized form) to the status byte (bit 3).

04_06 LDX-3232 55