Carrier Access SNMP manual Echo Echo Telnet output on serial line Off Disable Enable

Command Line Interface (CLI)

interface	IP Interface
leds	Leds on unit
signal	FX Signal Type by Channel
snmp	SNMP Interface
tcp	TCP Interface
udp	UDP Interface
xmodem	XMODEM Interface
telnet	Set Telnet Session Configuration
echo	Echo Telnet output on serial line
off	Disable	echo
on	Enable	echo
time	Display/Set Time: time hr:mm:ss
trap	Send Warm Start Trap to SNMP
n updown	Send Link Up or Link Down for I/F #n
v35	Display/Set V.35
circuitid	V.35 Circuit ID
clkinv	Clock Inversion
none	No Clocks Inverted
rx	Receive Clock Inverted
rxtx	Both Clocks Inverted
tx	Transmit Clock Inverted
cts	CTS Signal Control
cd	CTS Follows CD Signal
high	CTS Always High
low	CTS Always Low
rts	CTS Follows RTS Signal
datainv	Data Inversion
invert	Data Inverted
none	Data Not Inverted
rxclk	Receive Clock Source
internal	Internal Clock (same as TX)
external	External Clock
send	Send Test Data on Port
clear	Clear Test Data Statistics
error	Inject Single Error on Port
off	Stop Send for Normal Operations
loopdown	Send In-Band Remote Loop Down
loopup	Send In-Band Remote Loop Up
statistics	Display Send Statistics
network	Send Pattern to Network
[p] [r]	p - optional pattern
	alt	- alternating 1/0
	d4up	- D4 loopup: 00001
	d4dn	- D4 loopdown: 001
	ones	- all ones
	p1in8	- 00000001
	p511	- O.153
	p2047	- O.152

9/24/01 14-17