Carrier Access SNMP manual FXS-ID Configuration, FXS-ID Voice Card

Chapter 8

FXS-ID Configuration

Contents of This Chapter:

About This Chapter	1	FXS Signaling Option Descriptions	.......... 8
FXS-ID Voice Card	1	Option Switches A, B, and C	8
Signaling Types	2	TP Busy/Idle Switch	11
FXO Switch to AB2 FXS A/B Signaling ..... 2		Voice Channel Monitoring and Testing .. 11
Wink-Start to Loop-Start or Ground-Start ..	2	FXS Backplate Switches	12
Wink Delay	3	FXS Backplate LEDs	12
Setting the Transmit and Receive Levels ..	3	“Busying Out” Individual FXS Channels . 12
Setting the Signaling Options	6	Self Test Loopbacks	13
Option Switches A, B, and C	6

8.1 About This Chapter

This chapter describes how to configure the Access Bank II - SNMP Foreign Exchange Station - Caller ID (FXS - ID) 12-channel voice card for connection to T1 public network services and pro- vides instructions for:

•Setting FXS Transmit and Receive Levels

•Setting FXS Signaling Type Options

•Performing FXS Voice Channel Monitoring and Testing

8.2FXS-ID Voice Card

The Foreign Exchange Station - Caller ID (FXS-ID) 12-channel voice card delivers high quality loop-start or ground-start dial tone telephone line connections to key systems, Off Premise Exten- sions (OPXs), facsimile machines, modems, PBXs and other conventional analog telephone devices. The FXS - ID card supports the Caller ID CLASSÆ feature. The FXS -ID, is a 7.8” by 13.16” daugh- ter card designed to slide into the back of the Access Bank II - SNMP along rails that guide a 64-pin DIN connector to mate with a matched connector on the internal AB2 Controller. The FXS-ID card receives the T1 signaling, tip and ring pairs, control logic and power through this connector. The back

9/24/01 8-1