Carrier Access SNMP manual 1 RJ-48C Jacks for T1 Span 1 and Span, Snmp Connector

Access Bank II SNMP Control Panel Interface and Power Connectors

005-0009-	25 foot,	Twenty-five-foot V.35 Data Cable for con-	Fine Pitch D-Sub-26
DCE-	7.62 m	necting a router or other digital device to a	Male to DCE V.35
MM-25’		T1 network using the Access Bank II	Male
		SNMP’s V.35 DCE data port, accommodat-
		ing high-speed transfers up to 1.536 Mbps.
		This cable is optional and must be ordered
		separately.
005-0010-	50 foot,	Fifty-foot V.35 Data Cable for connecting a	Fine Pitch D-Sub-26
DCE-	15.24 m	router or other digital device to a T1 net-	Male to DCE V.35
MM-50’		work using the Access Bank II SNMP’s	Male
		V.35 DCE data port, accommodating high-
		speed transfers up to 1.536 Mbps. This cable
		is optional and must be ordered separately.

5.3Access Bank II SNMP Control Panel Interface and Power Connectors

1	1	Span Setup	Self Test 1 Network Loopback 1 T1 Framing 1 T1 Line Code 1 CSU On/Off 1 Self Test 2 Network Loopback 2 T1 Framing 2 T1 Line Code 2 CSU On/Off 2
T1 Span	T1 Span	T1

SNMP/TELNET

System Setup

Figure 5-1: Interface and Power Connectors on the Access Bank II SNMP Control Panel.

5.3.1 RJ-48C Jacks for T1 Span 1 and Span 2

One (or two) 10-foot modular Category 5 T1 Network Interface Cables are used to connect the RJ- 48C 8-pin connectors to the T1 carrier network RJ-48C jack(s).

5.3.2 SNMP Connector

The Access Bank II SNMP is equipped with an RJ-45 jack for accessing an embedded SNMP agent via a customer provided cable.

5.3.3 V.35 DCE Data Port Connector

The optional CAC V.35 Data Cable (10’, 25’ or 50’) with a micro-D 26-pin (male) to 34-pin Win- chester connector (male) connects this 26-pin V.35 DCE data interface connector (female) to cus- tomer premise DTE.

5.3.4 DC Power Connector Input

Power connections are made to the DC Power Connector Input with a three-position removable wir- ing connector on the 8-foot DC power cord from the 115 Vac to -48 Vdc Power Conversion Cube.

9/24/01 5-3