Carrier Access SNMP manual Status Commands, 14.4.4.30, 14.4.5.1equipment

14.4.4.30 v35

Use the v35 command to configure parameters for the V.35 data port to be accessed by the SNMP manager via RFC-1659.

Operations	Type	Comments
To set the circuit ID to	v35 circuitid “V.35 - 1”	Sets the Circuit Id for the V.35 port
“V.35 - 1”
To set clock inversion to	v35 clkinv rx	Sets the receive clock to be inverted.
receive clock inverted
To set CTS to follow	v35 cts rts	Sets CTS to follow RTS signal
RTS signal
To set data inversion	v35datainv invert	Sets the V.35 data to be inverted.
To set receive clock	v35 rxclk internal	Sets thte system to use the Internal
source to be internal		Clock.
To set the speed to be	v35 speed nx56	Sets the data raste to Nx56 KBps
nx56
To display Help	v35 ?

14.4.5 Status Commands

14.4.5.1equipment

Use the equipment command to display the hardware equipment configuration within the Access Bank.

Operations	Type	Comments
To display the equipment	equipment	Displays a list of the current installed
list		hardware and Firmware revision
		levels.

14-28 9/24/01