Table 12-5: T1 Test LEDs for T1 Span 1 and 2

State

Meaning

GREEN

Normal operations. Trunk process-

 

ing, self test, and network loopback

 

inactive.

 

 

FLASHING GREEN

T1 Self Test local loopback passed.

 

 

RED

T1 Self Test local loopback failed

 

due to one or more of the following

 

conditions: T1 Loss of Signal, Out of

 

Frame, Improper Line Code

 

Received, ESF or BPV errors

 

received.

 

 

YELLOW

Channels held in Trunk Processing

 

for this T1 span.

 

 

FLASHING YELLOW

Network loopback active for this T1

 

span.

Table 12-6: V.35 Status LED

State

Meaning

OFF

No T1 channels assigned to V.35

 

port.

 

 

GREEN

CD (RLSD) and RTS leads active. T1

 

channels assigned and operative.

 

 

FLASHING GREEN

V.35 in loopback to equipment.

 

 

RED

CD (RLSD) lead is inactive because

 

assigned T1 is inoperative.

 

 

YELLOW

CD (RLSD) lead active. RTS lead

 

inactive.

 

 

FLASHING YELLOW

V.35 in loopback to T1 line.

12.12 Fault Isolation Procedures

This section lists typical trouble symptoms that may occur while operating the Access Bank II - SNMP and suggests appropriate corrective actions to take. Fault symptoms are organized into three groups:

Control Panel LED indications (system, T1 or V.35 faults)

Back Plate LED indications (voice circuit faults)

Other fault indications

12-14

9/24/01

Page 135
Image 135
Carrier Access SNMP manual Fault Isolation Procedures, T1 Test LEDs for T1 Span 1, V.35 Status LED