Carrier Access SNMP manual Context sensitive help, type ? at any time

Command Line Interface (CLI)

commands, including all levels of options for each command. Typing help after a command name provides a list of the command options at all levels.

1. Type ? at the prompt to list all of the commands, as shown below.

Commands	Command Line Interface Help. For immediate
	context sensitive help, type ? at any time.
	For full command help, type “help” after
	any partial command.
\	Enter \ to go to the top command level
aco	Display/Set	Alarm Cutoff
alarms	Display/Set	current alarms
aps	Display/Set Automatic Protection Switching
boot	(Re)Boot the system...		all connections
	will be dropped during initialization
clk	Display/Set	T1 Clock
config	Set/Restore	Configuration
connections	Display Connections
craft	Display/Set	Craft Port
date	Display/Set	Date: date mm/dd/yyyy
dni	Display/Set	DNI (DS1 to DS1) properties
dialout	Display/Set	dialout alarm enables
ds1 [nall]	Display/Set	DS1 n=1..2 or all DS1s
equipment	Display the	Equipment List
event	Display the	next 18 events
exit	Exit Command Line Interface
ip	Display/Set	IP Parameters
kill	Kill Connection Assignments
log	Display/Set	log enables
loop	Display/Set	Loopback State
mac	Display 6 byte MAC addr in Hex
make	Display/Make Connection Assignments
name	Display/Set	Name Configuration
password	Change password
ping ipaddr [n] [d] Send IP Ping to ipaddr up to n times
	with d ms delay between pings
rs232	Display/Set	Optional Data RS-232 Port
screen height [width]Display/Set CRT screen size
snmp	Display/Set	SNMP System Group Settings
statistics	Display Statistics
status	Display Status of Interface(s)
telnet	Set Telnet Session Configuration
time	Display/Set	Time: time hr:mm:ss
trap	Send Warm Start Trap to SNMP
v35	Display/Set	V.35
verbose	Display/Set	Command Fill Verbose Mode
version	Display Version Numbers in System

9/24/01 14-9