Carrier Access SNMP manual Alarms, Control Panel I/O Connectors, Standards Compliance

Alarms

Access Bank II - SNMP purchase.

•Control Panel T1 test switches and status LEDs

•Rear panel voice channel option switches, test switches, and status LEDs

•Embedded SNMP agent for performance monitoring and configuration of T1, V.35, and RS-232 data ports

3.14Alarms

•Alarm dial-out notification over external modem attached to RS-232 Management port

•External alarm contact for visible/audible alarms using pair 25 of RJ-21X standard tele- phony connector on Control Panel

•Control Panel Alarm Cut-Off (ACO) Switch

3.15Control Panel I/O Connectors

•T1 Span 1 and Span 2: Standard RJ-48C 8-pin jacks

•V.35 DCE Data Port: 26-pin D-type subminiature V.35 connector (female)

•Management Interfaces:

•Management: Primary logical RS-232 port for connection to external Hayes-compat- ible modem or to IBM-PC (or compatible) with MS Windows Hyperterm (or com- patible), and MS Windows-based Remote Monitor software program installed

•Data: Secondary logical RS-232 data port

•Connector: 26-pin D-type subminiature EIA/TIA RS-232 connector (female)

•Adapter Cable: Dual RS-232 Management Cable for simultaneous connection to Data and Management RS-232 interface lead

•SNMP RJ-45 jack for 10Base-T Ethernet TCP/IP connection.

•Tip & Ring Interface:Standard 25-pair RJ-21X Telephony Connector (female)

3.16Standards Compliance

•ANSI/TIA T1.403-1995 One-second Performance Report Messages (PRMs)

•ANSI/TIA 464-A-89 PBX Switching Equipment for Voice Band Applications

•AT&T 54016 Maintenance Messages on the 4 Kbps ESF Facility Data Link (FDL)

•AT&T 62411 Enhanced Stratum 4 Timing Requirements for T1 CPE

•AT&T 62411 Standard T1 Pulse Mask Characteristics

•Bellcore TR-TSY-000057 for Digital Loop Carrier Systems

9/24/01 3-5