Carrier Access SNMP manual FXS Transmit and Receive Level Option Settings

FXS-ID Configuration

If your FXS voice channels require different attenuation level settings than the factory defaults, pro- ceed as follows:

1.Release the two thumbscrews on the AB2 back plate and remove the plate (see Figure 8-2).

2.To remove the FXS-ID slide-in voice card, pull out the two card ejector latches simulta- neously to release the card from the internal connector, then slide the card carefully out from the rear of the AB2 chassis (see Figure 8-2).

3.To set different transmit and/or receive gain or loss levels, refer to Figure 8-1and Table 8-1.

4.To reinsert the FXS-ID voice card, ensure that the card is positioned correctly in the card rails, then carefully slide the card into the slot until it stops.

5.Press both card ejector latches in towards the FXS-ID card to seat the 64-pin DIN connector in the matching connector on the internal Controller card.

6.After setting the transmit and receive level options, replace the back plate and tighten the thumbscrews.

Table 8-1: FXS Transmit and Receive Level Option Settings

Switch	Function (Switch OFF)
1	-2 dB Receive Loss
2	-3 dB Receive Loss
3	-4 dB Receive Loss
4	-2 dB Transmit Loss
5	-3 dB Transmit Loss
6	-4 dB Transmit Loss

8-4 9/24/01