This manual is organized into chapters as follows:
Chapter 1. Introducing the Access Bank II - SNMP
Provides a general introduction to the Access Bank II - SNMP including summaries of its standard functions, fea-
tures, and optional enhancements.
Chapter 2. Product Description
Describes the general physical characteristics and layout of the Access Bank II - SNMP, including the Control Panel,
digital and analog interface connectors, power connector, DIP switches and LED status indicators.
Chapter 3. Technical Specifications
Summarizes the technical specifications of the Access Bank II - SNMP, including its dual T1 networ k interfaces,
integral Channel Service Units (CSUs), digital data ports, analog li ne interfaces, network management capabil-
ities, alarms, standards, power sources and environmental operating parameters.
Chapter 4. Physical Installation
Provides procedures for physically installing the Access Bank II - SNMP including checking items required for in-
stallation and mounting the chassis and power converter.
Chapter 5. Electrical Installation
Provides procedures for installing the communication interface and power connectors on the Access Bank II -
SNMP Control Panel and bringing the unit on line.
Chapter 6. Initialization and Basic Configuration
Describes how to initialize and configure the Access Bank II - SNMP for first time basic operation in the Local mode
using the System Configuration and T1 Hardware Configuration DIP switches.
Chapter 7.12-Channel FXS Card
Describes how to configure the Foreign Exchange Station (FXS) 12-channel voice card for connection to T1
public network services and provides instructions for setting signaling options and channel attenuation levels,
and performing voice channel monitoring and testing.
Chapter 8. 12-Channel FXO Card
Describes how to configure the Foreign Exchange Office (FXO) 12-channel voice card for connecting the Access
Bank II - SNMP to T1 public network services and provides instructions for optioning the FXO.
Chapter 9. Diagnostics & Troubleshooting
This Chapter provides instructions for performing self-test loopbacks, network loopbacks, disabling external
alarms, as well as fault isolation procedures for troubleshooting typical problems encountered while operating
the Access Bank II - SNMP
Chapter 10. Maintenance
Provides procedures for maintaining the Access Bank II - SNMP including “hot swapping” slide-insert voice
cards and replacing the Controller card.