Carrier Access SNMP manual RS-232 Management, 1 RS-232 DCE Management Cable Local Management Cable

5.7 RS-232 Management

5.7.1 RS-232 DCE Management Cable

Note: The Dual RS-232 DCE Data and Management Cable (P/N 005-0001) is an optional accessory, and can be purchased from distributors and dealers of CAC products.

5.7.2 Local Management Cable

To perform local or remote management and performance monitoring using the Command Line Inter- face or MS Windows-based Remote Monitor software installed in a local PC or laptop computer requires using the CAC 25-Pin Local Management Cable (P/N 005-0003). This 10-foot cable is equipped with a 26-pin male D-type subminiature connector on the end that mates with the Access Bank II SNMP RS-232 secondary data port (COM2) and a DB25 female connector on the DCE end for connection to the RS-232 communications interface of the local PC or laptop. Both this cable and

a25-pin to 9-pin “straight adapter” (P/N 005-0007-25M-9F-Straight)are included with the Access Bank II SNMP, permitting attachment to laptop computer DB9 ports.

Figure 5-5 shows these connectors and connection points.

	10 ft.
D-SUB-26 (male)		DCE-DB-25
SECONDARY	BRAID	(female)
1 SHIELD		1 SHIELD
7 GND	GND	7 GND
	TXD
14 STXD		2 TX
	RXD		Local PC with Remote
16 SRXD		3 RX
	RTS		Monitor Software
19 SRTS		4 RTS
	CTS
13 SCTS		5CTS
	DTR
10 SDTR		20DTR
	CD
12 SCD		8CD

RS-232 Management

Data Port (Com2) on

Nodal Switch

Figure 5-5: CAC Local Management Cable

The CAC Local Management Cable is built according to the pin assignments listed in Table 5-6.

5-10 9/24/01