Carrier Access SNMP manual CommandLineInterfaceHelp.Forimmediate

2. Type help at the prompt to list all of the commands and options, as shown below.

Commands		CommandLineInterfaceHelp.Forimmediate
		context sensitive help, type ? at any
		time.
		Forfullcommand help, type“help”after
		any partial command.
\		Enter \ to go to the top command level
aco		Display/Set Alarm Cutoff
off		Disable	alarm
on		Enable	alarm
alarms		Display/Set current alarms
all onoff		Set all alarms
sys		Display/Set system alarms
power	onoff .. Hard reset or power on detected
brownout	onoff .. Brown out detected
reset	onoff .. Soft reset detected
vn		Display/Set alarms for V.35 #n
rts	onoff .. Loss of V.35 RTS
llb	onoff .. Local Loop Back detected
v54	onoff .. Remote V.54 Loop Back detected
dn		Display/Set alarms for ds1 #n
carrier	onoff .. Loss of carrier detected
csuloop	onoff .. CSU loop code received
unframed	onoff .. Unframed, all 1’s received
sync	onoff .. Loss of sync
yellow	onoff .. Yellow alarm received
bpv	onoff .. BPVs exceed 1544 in 15 min period
ses	onoff .. SES exceed 10 in 15 min period
unavail	onoff .. Unavailable seconds in 15 min period
fdlline	onoff .. FDL line loop request received
fdlpay	onoff .. FDL payload loop request received
aps		Display/Set Automatic Protection Switching
off		Disable APS mode
primary dn		Set either d1 or d2 as primary span
threshold n		Set BPV switch threshold to 10^-n, 4<=n<=6
boot		(Re)Boot the system...		all connections
		will be dropped during initialization
clk		Display/Set T1 Clock
primary		Set T1 Primary Clock Source
t11		Set Clock Source to T1 #1
t12		Set Clock Source to T1 #2
internal		Set Clock Source to internal
secondary		Set T1 Secondary Clock Source

14-10 9/24/01