Carrier Access SNMP manual Dpt

		0: FXS	Loop or Ground Start
		1: FXS	Ground Start
		2: FXS	Loop Start
		3: FXO	Loop or Ground Start
		4: FXO	Ground Start
		5: FXO	Loop Start
		6: E&M	Immediate Start
		7: E&M	Wink Start
		8: E&M	Wink Start ANI/DNIS
		9: E&M	DPT
type		Display DNI Channel Type
s:c [n] opt		Set Channel Type for [n] channels from s:c
		clear	-- for data or bypass
		voice	-- for voice signaling
dialout		Display/Set dialout alarm enables
all onoff		Set all alarm enabless
pager		Display/Set pager device strings
““ ““		Disable pager device
“phone” “msg” .... Dial phone and msg (blanks ignored)
printer		Display/Set printer device strings
““ ““		Disable printer device
“phone” “notify” . Dial phone, report for “notify”
“DIRECT” “notify” Direct connect report for “notify”
sys		Display/Set system alarms
power	onoff .. Hard reset or power on detected
brownout	onoff .. Brown out detected
reset	onoff .. Soft reset detected
vn		Display/Set alarm enables for V.35 #n
rts	onoff .. Loss of V.35 RTS
llb	onoff .. Local Loop Back detected
v54	onoff .. Remote V.54 Loop Back detected

dn		Display/Set alarm enables for ds1 #n
carrier	onoff ....	Loss of carrier detected
csuloop	onoff ....	CSU loop code received
unframed	onoff ....	Unframed, all 1’s received
sync	onoff ....	Loss of sync
yellow	onoff ....	Yellow alarm received
bpv	onoff ....	BPVs exceed	1544 in 15 min period
ses	onoff ....	SES exceed 10 in 15 min period
unavail	onoff ....	Unavailable	seconds in 15 min period
fdlline	onoff ....	FDL line loop request received
fdlpay	onoff ....	FDL payload	loop request received
ds1 [nall]		Display/Set	DS1 n=1..2 or all DS1s
circuitid “id”		DS1 Circuit	ID
csu		Set DS1 CSU
off		Do not respond to CSU code
on		Respond to CSU code
lbo		Set DS1 Line Build Out

14-12 9/24/01