Gianni Industries ST-630E specifications Controller Station Setting, Anti Pass Back Function

ⅣOperation Instruction:

*xxxxxx#		Enter Program Mode，Enter 6-digital Codes，(Default 123456)
* #		Exit Program Mode
01*xxxxxx xxxxxx #		Change Default Password, Press twice new 6-digital Codes
02*xxxx #		Controller Station Setting				001-254
						［	］
05*xxx#		Access only with the password, 0000-Unavaliable (Default, 0000)
10*xxxx*XXXXXXXXXX #		Adding or Revised the Cards No.
		Slot Position =00001~01000 and enter the 10 digital Cards No.
12*XXXX*XXXXX#		Adding the batch series Cards No.. XXXX=the beginning position
		*XXXXX=the quantities of the batch series card No.
		(The access mode is for Card Only)					(ps. x≦01000)
13*xxxxx*XXXXX*N #		Modify the cards access parameter
		xxxxx= The beginning slot position
		XXXXX= the ending slot position					From=00001~01000
		N is 0= Access not allow，1=Card only， 2=Cards or Code，
		3=Card & Code， 4= Clear card information
		(When modify the Mode to “Card or Code” or “ Card & Code”，the
		default Code is 0000.
14*xxxxx*XXXX#		Set the position of the Code; xxxxx=slot position XXXX=4-digital
		Code	(Position =00001~01000)
15*99#		Clear all Cards (Not including Master Cards)
17*xxxxxxxxxx#		When forget the Cards slot position，can clear the cards information
		by enter Cards No..
21*xxx#		Alarm Time Delay Setting			xxx=000~255 Seconds
22*xxx#		Dual relays programmable time delay xxx=000~250 Seconds
		(External Relay for Security System)
		(000 Latched Operation)			(Default is 15 Seconds)
25*X#		Master Cards Setting x=(1 or 2). 2 Master Card available
		In the normal status, proximity the Master cards to Program Mode.
26*xxxxx*XXXXX#		Security Cards arrange Setting XXXXX=00001~01000 .The arrange
		of the No. should be continuing which can’t skip the No.
30*x#		x=0	General Setting Mode (Default x=0)
		x=1 Card Only. Access the door by reading cards that no matter the
		cards are set into the system or not.
32*x#		Anti Pass Back Function
		x=0/ OFF		X=1/ ON
33*x#		Two Doors Synchronize				x=0	OFF X=1 ON Access
							，
Copyright All Rights Reserved.							Page 3 of 5
P-MU-ST-630 Ver. A	Publish: 2009.01.08