ICP DAS USA 8430, 8KE8, 8KE4, 8830 #01S31C01, #01S31A00cr, Command, Description, Syntax, Example

# AASiBjDS For single channel DO output

Command	#AASiBjDs
Description	This command sends the value to the digital output module of the specified
	channel and slot of the I-8000 unit. This command is only for output
	modules which the channel number is less than or equal to 16.
Syntax	#AASi1BDs[CHK](cr)
	$	A delimiter character
	AA	A 2-character HEX module address for the specified
		I-8000 unit ,ranging from 01 to FFh
	Si	The specified slot number. i = 0 to 3(4 slots) or
		i = 0 to 7(8 slots)
	Bj	The channel to be set will contain two characters.The
		first character ‘B’ is always be number 1, and the
		second character ‘j’ indicates the channel will be set
		and ranging from 0 to F.
	Ds	For single channel output the data will contain two
		character. The first character ‘D’ is always 0. The
		second character is ether 0 or 1. 0 => OFF, 1 => ON.
	[CHK]	2-characters of Checksum
	(cr)	Carriage Return (0x0D) to denote the end of	the
		command
	Valid Command	>[chk](cr)
	Invalid Command	?AA[CHK](cr)
	Any syntax or communication error may receive no response.
	>	A delimiter for valid command
	?	A delimiter for invalid command
	[CHK]	A 2-character of checksum
	(cr)	Carriage Return (0x0D) to denote the end of	the
		response
Note	If any channel of	digital output module (*1) is configured for an analog
	input alarms then this command has no effect on the specified channel.
	The channel is always used for analog input alarms and can not be
	configured again unless it is disconnected.
	Refer to: Analog Input Alarm
	(*1) For digital output modules not support analog input alarm are :
	i-8041, i-87041, i-87042, i-8050
Example	Command	#01S31C01
	Response	>(cr)
	Description	This example is for a single channel. The Digital
		output Module in slot 3 and channel 12 (0Ch) of the
		I-8000 unit at address 01h will be set to ON. This
		example is only for output modules which the channel
		number is less than or equal to 16.
	Command	#01S31A00(cr)
	Response	>(cr)

8430/8830/8KE4/8KE8 User’s manual, Jan 2005, Version 1.0, 8MS-002-10 ----- 78