Dell R805 Time-of-day not, Set please run, Setup program, Timer chip, Combination, Utility

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
Time-of-day not	Incorrect Time or Date	Check the Time and Date
set - please run	settings; faulty system	settings. See "Using the
SETUP program	battery.	System Setup Program" on
		page 47. If the problem
		persists, replace the system
		battery. See "System Battery"
		on page 125.
Timer chip	Faulty system board.	See "Getting Help" on
counter 2 failed		page 175.
Unsupported CPU	Microprocessor(s) is not	Install a supported
combination	supported by the system.	microprocessor or
Unsupported CPU		microprocessor combination.
		See "Processors" on page 120.
stepping
detected

TPM failure	A Trusted Platform Module
	(TPM) function has failed.
Utility	The <F10> key was pressed
partition not	during POST, but no utility
available	partition exists on the boot
	hard drive.
Warning:	Faulty or improperly seated
Following faulty	memory module(s). DIMMs
DIMMs are	are disabled in pairs, as
disabled:	indicated by the n1 and n2.
DIMM n1 n2	Check both DIMMs for a
	possible fault.
Total memory size
is reduced.
Warning: A fatal	A fatal system error occurred
error has caused	and caused the system to
system reset!	reboot.
Please check the
system event log!

See "Getting Help" on page 175.

Create a utility partition on the boot hard drive. See the CDs that came with your system.

See "Troubleshooting System Memory" on page 150.

Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 137 for any faulty components specified in the SEL.

About Your System

43