Dell R805 ROM bad checksum, Sector not found, Seek error, Seek operation, Shutdown failure

Table 1-7. System Messages (continued)

Message	Causes	Corrective Actions
ROM bad checksum	Expansion card improperly	Reseat the expansion card(s).
= address	installed or faulty.	Ensure that all appropriate
		cables are securely connected
		to the expansion card(s). If
		the problem persists, see
		"Troubleshooting Expansion
		Cards" on page 158.
Sector not found	Faulty hard drive, USB	See "Troubleshooting a USB
Seek error	device, or. USB medium.	Device" on page 143 or
		"Troubleshooting a Hard
Seek operation
		Drive" on page 155 for the
failed
		appropriate drive(s) installed
		in your system.
Shutdown failure	Shutdown test failure.	See "Troubleshooting System
		Memory" on page 150.

The amount of	Memory has been added or
system memory has	removed or a memory
changed	module may be faulty.

This system	Microprocessor(s) is not
supports only	supported by the system.
Opteron(TM) 2000
series
processors.
Time-of-day	Faulty battery or faulty chip.
clock stopped

If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module. See "Troubleshooting System Memory" on page 150.

Install a supported microprocessor or microprocessor combination. See "Installing a Processor" on page 123.

See "Troubleshooting the System Battery" on page 147.

42

About Your System