Dell R805 Removing the Processor Cooling Shroud, Installing the Processor Cooling Shroud

Removing the Processor Cooling Shroud

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Open the system. See "Opening the System" on page 71.

3Detach and remove the two memory module cooling shrouds on each side of the processor cooling shroud.

4Remove the expansion cards from expansion-card riser 2. See "Removing an Expansion Card" on page 92.

5Remove expansion-card riser 2. See "Removing Expansion-Card Riser 2" on page 101

6Lift the shroud upward and out of the system. See Figure 3-15.

Installing the Processor Cooling Shroud

1Align the pin collars at the bottom of the processor cooling shroud with the pins located on the two fan brackets. See Figure 3-15.

2Lower the processor cooling shroud straight down onto the pins.

3Reinstall expansion-card riser 2. See "Replacing Expansion-Card Riser 2" on page 101.

4Reinstall the expansion cards into the riser 2 board. See "Installing an Expansion Card" on page 91.

Installing the Memory Module Cooling Shrouds

1Align the pin collars at the bottom of the right ("B") memory module cooling shroud with the pins located on the right side of the "B" memory module slots. See Figure 3-15.

2Lower the shroud straight down onto the pins and press down lightly to latch the shroud to the processor cooling shroud.

3Lower the left ("A") memory module shroud over the "A" memory modules and press down lightly to latch the shroud to the processor cooling shroud.

4Close the system. See "Closing the System" on page 71.

5Reconnect the system to the electrical outlet and turn on the system and attached peripherals.

96

Installing System Components